add gpio-line-mux

This proposes a new type of virtual GPIO controller and corresponding
driver to provide a 1-to-many mapping between virtual GPIOs and a single
real GPIO in combination with a multiplexer. Existing drivers apparently
do not serve the purpose for what I need.

I came across an issue with a switch device from Zyxel which has two
SFP+ cages. Most similar switches either wire up the SFP signals
(RX_LOS, MOD_ABS, TX_FAULT, TX_DISABLE) directly to the SoC (if it has
enough GPIOs) or two a GPIO expander (for which a driver usually
exists). However, Zyxel decided to do it differently in the following
way:
  The signals RX_LOS, MOD_ABS and TX_FAULT share a single GPIO line to
  the SoC. Which one is actually connected to that GPIO line at a time
  is controlled by a separate multiplexer, a GPIO multiplexer in this
  case (which uses two other GPIOs). Only the TX_DISABLE is separate.

The SFP core/driver doesn't seem to support such a usecase for now, for
each signal one needs to specify a separate GPIO like:

  los-gpio = <&gpio0 0 GPIO_ACTIVE_HIGH>;
  mod-def0-gpio = <&gpio0 1 GPIO_ACTIVE_LOW>;
  ...

But for my device, I actually need to directly specify multiplexing
behavior in the SFP node or provide a mux-controller with 'mux-control'.

To fill this gap, I created a dt-schema and a working driver which
exactly does what is needed. It takes a phandle to a mux-controller and
the 'shared' gpio, and provides several virtual GPIOs based on the
gpio-line-mux-states property.

This virtual gpio-controller can then be referenced in the '-gpio'
properties of the SFP node (or other nodes depending on the usecase) as
usual and do not require any modification to the SFP core/driver.

---
Changelog:

v2: - as requested by Linus:
      - renamed from 'gpio-split' to 'gpio-line-mux'
      - added better description and examples to DT bindings
    - simplified driver
    - added missing parts to DT bindings
    - dropped RFC tag
    - renamed patchset

Link to v1 (in case it isn't linked properly due to changed title):
https://lore.kernel.org/linux-gpio/20251009223501.570949-...

---
Jonas Jelonek (2):
  dt-bindings: gpio: add gpio-line-mux controller
  gpio: add gpio-line-mux driver

 .../bindings/gpio/gpio-line-mux.yaml          | 108 ++++++++++
 .../devicetree/bindings/mux/gpio-mux.yaml     |  30 +++
 MAINTAINERS                                   |   6 +
 drivers/gpio/Kconfig                          |  10 +
 drivers/gpio/Makefile                         |   1 +
 drivers/gpio/gpio-line-mux.c                  | 194 ++++++++++++++++++
 6 files changed, 349 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/gpio/gpio-line-mux.yaml
 create mode 100644 drivers/gpio/gpio-line-mux.c


base-commit: 897396b418d1720aac39585b208aada708b5b433
-- 
2.48.1