|| ||Wenyou Yang <firstname.lastname@example.org> |
|| ||email@example.com |
|| ||[v4 PATCH 00/12] atmel spi controller with dmaengine and device tree
|| ||Mon, 14 Jan 2013 15:34:25 +0800|
|| ||firstname.lastname@example.org, JM.Lin@atmel.com, email@example.com,
firstname.lastname@example.org, email@example.com, firstname.lastname@example.org|
|| ||Article, Thread
This set of patches is to add dmaengine and device tree support for atmel spi.
The work is based on Nicolas and Richard's work.
It is tested on at91sam9x5ek, at91sam9m10g45ek, at91sam9263ek and at91sam9g20ek.
It is based on v3.8-rc3.
1./ Take Joe Perches's advance, rewrite atmel_spi_is_v2(struct atmel_spi *as)
and atmel_spi_use_dma(struct atmel_spi *as),
and remove atmel_spi_use_pdc(struct atmel_spi *as).
2./ Rebase on v3.8-rc3.
1./ Rebase on v3.8-rc2.
2./ Remove some Jean-Christophe's patches which has been
applied on v3.8-rc2.
3./ Remove spi property "cs-gpios" from the SoC dtsi files
to the board dts files to avoid some useless pin conflicts.
1./ Remove the patch :PATCH]mtd: m25p80: change the m25p80_read to reading page to page
which purpose to fix the BUG: when run "flashcp /bin/busybox /dev/mtdX" in
the at91sam9g25ek with DMA mode, it arises a OOPS.
Now fix it in this patch:
[PATHC] spi/atmel_spi: add dmaengine support changing to fix the [BUG].
2./ Remove two patches:
which purpose to read dts property to select SPI IP version and DMA mode
Now they will be gat from device tree different compatile.
3./ Fix DMA: when enable both spi0 AND spi1, the spi0 doesn't work BUG.
4./ Rebase v3.7-rc8.
Nicolas Ferre (5):
spi/atmel_spi: add physical base address
spi/atmel_spi: call unmapping on transfers buffers
spi/atmel_spi: status information passed through controller data
spi/atmel_spi: add flag to controller data for lock operations
spi/atmel_spi: add dmaengine support
Richard Genoud (6):
spi/atmel_spi: fix spi-atmel driver to adapt to slave_config changes
spi/atmel_spi: correct 16 bits transfers using PIO
spi/atmel_spi: correct 16 bits transfer with DMA
ARM: at91: add clocks for spi dt entries
ARM: dts: add spi nodes for atmel SoC
ARM: dts: add spi nodes for the atmel boards
Wenyou Yang (1):
spi/atmel_spi: update the dt support
arch/arm/boot/dts/at91sam9260.dtsi | 18 +
arch/arm/boot/dts/at91sam9263.dtsi | 18 +
arch/arm/boot/dts/at91sam9263ek.dts | 14 +
arch/arm/boot/dts/at91sam9g20ek_common.dtsi | 14 +
arch/arm/boot/dts/at91sam9g45.dtsi | 18 +
arch/arm/boot/dts/at91sam9m10g45ek.dts | 14 +
arch/arm/boot/dts/at91sam9n12.dtsi | 18 +
arch/arm/boot/dts/at91sam9n12ek.dts | 14 +
arch/arm/boot/dts/at91sam9x5.dtsi | 18 +
arch/arm/boot/dts/at91sam9x5ek.dtsi | 14 +
arch/arm/mach-at91/at91sam9260.c | 2 +
arch/arm/mach-at91/at91sam9g45.c | 2 +
arch/arm/mach-at91/at91sam9n12.c | 2 +
arch/arm/mach-at91/at91sam9x5.c | 2 +
drivers/spi/spi-atmel.c | 809 ++++++++++++++++++++++++---
15 files changed, 908 insertions(+), 69 deletions(-)